Error P0387 on JAC все модели
Crankshaft Position Sensor B Circuit Low
Code
P0387
Vehicle
JAC все модели
Category
Powertrain
Severity
🚨 CriticalSymptoms
- The engine does not start or starts with great difficulty
- Unstable operation, frequent engine stops
- No spark or injection
- Check Engine Light Is On
- The ECU may go into emergency mode
Causes
- Short circuit of the sensor signal wire to ground
- No power supply to the sensor (open circuit)
- Air gap too large (sensor misaligned)
- Faulty sensor (internal failure)
- Sensor contamination blocking magnetic flux
How to Fix
- Read error codes, check sensor parameters at idle
- Check the sensor supply voltage (standard: 5V or 12V depending on the type)
- Check the signal wire for short circuit to ground (resistance between signal and ground should be high)
- Check the air gap between the sensor and the drive disk
- Check the sensor with an oscilloscope while cranking with the starter
- Replace crankshaft sensor B
FAQ
В чём разница P0387 и P0388?
P0387 — низкий уровень сигнала (КЗ на массу или слабый сигнал). P0388 — высокий уровень (КЗ на питание). Оба указывают на неисправность цепи датчика коленвала B.
Что делать если P0387 появился внезапно?
Часто внезапное появление связано с механическим повреждением датчика (удар о задающий диск при ослаблении крепления) или обрывом провода. Осмотрите датчик в первую очередь.