Error P0663 on Subaru все модели
Intake Manifold Tuning Valve Control Circuit/Open Bank 2
Code
P0663
Vehicle
Subaru все модели
Category
Powertrain
Severity
✅ LowSymptoms
- Check Engine light comes on
- Slight reduction in power or torque bank 2
- Slight asymmetry in engine operation (rarely felt)
- Slightly reduced efficiency
- The engine generally runs fine
Causes
- Open wire in bank 2 valve solenoid control circuit
- Broken bank 2 valve solenoid winding
- Oxidation or poor contact in the connector
- Blown fuse (if there is a separate one)
- ECU output stage fault for bank 2
How to Fix
- Measure the resistance of the bank 2 valve solenoid (normal: 10-30 ohms)
- Check for control voltage at the solenoid while the engine is running.
- Inspect the wiring and bank 2 solenoid connector
- Compare with bank 1 valve operation (both should behave the same)
- If the winding is broken, replace the solenoid
- If the wiring is broken, restore the wire
FAQ
Если банк 1 работает нормально, а банк 2 — нет, ощутима ли разница?
На большинстве автомобилей разница незначительна и практически не ощущается. Однако при езде с полной нагрузкой или на высоких оборотах тяга может быть чуть хуже нормы.
Нужно ли менять оба соленоида при неисправности одного?
Технически нет. Но если оба имеют большой пробег, разумно заменить оба одновременно, пока уже ведётся работа с проводкой и разъёмами.