Error P0667 on JAC все модели
Control Module Internal Temperature Sensor A Range/Performance
Code
P0667
Vehicle
JAC все модели
Category
Powertrain
Severity
⚠️ MediumSymptoms
- Check Engine light comes on
- Possible unreasonable power restrictions (if the ECU “thinks” it is overheating)
- Lack of thermal protection in case of real overheating
- In most cases there are no visible symptoms
- Code P0666 may appear at the same time
Causes
- Degradation of the internal temperature sensor of the ECU with age
- Incorrect operation of the ADC inside the ECU
- Previous exposure to moisture or overheating on ECU electronics
- ECU manufacturing defect
- Mechanical vibration damage to ECU chips
How to Fix
- Check the ECU temperature with a pyrometer or contact thermometer under different conditions
- Compare the readings of the internal sensor on the scanner with the measured temperature of the ECU housing
- Make sure that the ECU is installed correctly and that there is no overheating.
- Check the ECU connectors for moisture and corrosion
- ECU diagnostics on a specialized stand
- If confirmed, repair or replacement of the ECU
FAQ
Чем P0667 отличается от P0666?
P0666 — полная неисправность цепи датчика температуры ЭБУ (нет сигнала), P0667 — сигнал есть, но его значения недостоверны (датчик работает, но врёт).
Как проверить реальную температуру ЭБУ?
Бесконтактным пирометром (термометром) направьте на корпус ЭБУ после прогрева двигателя. Нормальная температура ЭБУ обычно 40–70°C. Если сканер показывает сильно другое значение — датчик неисправен.