Error P1702 on Subaru все модели
Auto Trans Diagnosis Input Signal Circuit
Code
P1702
Vehicle
Subaru все модели
Category
Powertrain
Severity
⚠️ MediumSymptoms
- Check Engine light comes on
- Car will not start in 'P' or 'N' position
- Incorrect display of the current gear on the instrument panel
- Transmission shifts incorrectly
- The car can start in any selector position
Causes
- Gear selector position sensor malfunction
- Open or short circuit in the sensor circuit
- Poor contact in circuit connectors
- Mechanical problems with the selector cable
- Transmission control module (TCM) malfunction
How to Fix
- Check the condition of the gear selector position sensor
- Check the integrity of the wiring and connectors in the circuit
- Check the mechanical connection between the selector lever and the gearbox
- Read sensor parameters using a diagnostic scanner
- If necessary, replace the position sensor or repair the wiring
FAQ
Можно ли временно устранить проблему P1702?
В некоторых случаях временным решением может быть очистка контактов датчика положения, но это не устранит основную проблему, если она связана с механическим износом.
Как проверить датчик положения селектора передач?
Для проверки необходимо измерить сопротивление датчика в разных положениях селектора и сравнить с заводскими характеристиками, а также проверить наличие опорного напряжения и целостность сигнального провода.