Error P0641 on JAC все модели
Sensor Reference Voltage A Circuit/Open
Code
P0641
Vehicle
JAC все модели
Category
Powertrain
Severity
🔴 HighSymptoms
- Check Engine light comes on
- Multiple sensor error codes appearing at the same time
- Engine in limp mode
- Unstable idle
- Dips when pressing gas
Causes
- 5 V reference circuit wire open
- Reference voltage circuit short to ground
- Damage to the wiring harness (frayed, pressed)
- Malfunction of one of the sensors connected to circuit A (short circuit inside the sensor)
- ECU malfunction (rare)
How to Fix
- Read all error codes - multiple sensor codes indicate a common circuit problem
- Check the 5V voltage at the signal pins of the sensors connected to circuit A
- Disconnect the sensors one by one and check if the voltage is restored (search for a sensor with an internal short circuit)
- Inspect the wiring harness for chafing or damage.
- If the wiring is correct - ECU diagnostics
- Replace the faulty sensor or repair the wiring
FAQ
Почему один код P0641 вызывает несколько кодов датчиков одновременно?
Потому что к одной цепи опорного напряжения 5 В подключено несколько датчиков. При обрыве этой цепи все они перестают получать эталонное напряжение и фиксируют ошибку.
Как найти неисправный датчик с внутренним замыканием?
Отключайте датчики от цепи A по одному, проверяя после каждого отключения напряжение — когда напряжение восстановится до 5 В, последний отключённый датчик и является неисправным.