Error P0660 on Tank все модели
Intake Manifold Tuning Valve Control Circuit/Open Bank 1
Code
P0660
Vehicle
Tank все модели
Category
Powertrain
Severity
✅ LowSymptoms
- Check Engine light comes on
- Reduced torque (valve stuck open) or maximum power (valve stuck closed)
- The engine performs slightly worse in a certain rpm range
- Otherwise the engine runs fine
- Possible extraneous hum from the intake manifold
Causes
- Open wire in valve solenoid control circuit
- Broken valve solenoid winding
- Lost contact in the IMTV valve solenoid connector
- Blown solenoid circuit fuse (if equipped)
- Malfunction of the ECU output stage (rare)
How to Fix
- Check the valve solenoid resistance with a multimeter (winding break)
- Check the voltage and presence of a control signal at the solenoid with the engine running
- Inspect the wiring and solenoid connector for breaks and oxidation.
- Check the solenoid circuit fuse
- If the wire is broken, repair or replace the wiring harness
- If the solenoid is faulty, replace the IMTV valve
FAQ
Клапан застрял в открытом или закрытом положении при P0660?
При обрыве цепи клапан остаётся в том положении, которое является «по умолчанию» для его пружины. Для большинства конструкций это открытое положение — для большей безопасности при отказе системы.
Как проверить обмотку соленоида?
Отсоедините разъём соленоида и измерьте его сопротивление мультиметром. Исправный соленоид клапана IMTV имеет сопротивление 10–30 Ом. Бесконечное сопротивление — обрыв, нулевое — КЗ.